5 Series E60 528xi (N52K) SAL
Unlock plug on control unit and disconnect.
Unlock tab (1), pull contact carrier (2) in direction of arrow out of
housing.
Unlock and disconnect all plug connections of ignition coil wiring
harness section in electronics box.
Release screws and remove holder (1).
Tightening torque 12 52 1AZ
.
Release screws and remove cable duct (1).
Installation:
Replace aluminium screws.
Tightening torque 12 52 2AZ
.
Work step
Note:
Unlock plug connections on ignition coils and disconnect
Unlock plug on eccentric shaft sensor and disconnect
Unlock plug on positioning motor for eccentric shaft and disconnect
Unlock plug on both solenoid valves and disconnect
Unlock plug on inlet and exhaust camshaft sensors and disconnect
Unlock plug on A/C compressor and disconnect
Unlock plug on oil pressure switch and disconnect
Unlock plug on coolant temperature sensor and disconnect
Disconnect connector strip from injection pipe
Remove front underbody protection
RA Replacing wiring harness section for ignition coil (N52)
BMW AG - TIS
21.02.2013 11:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
