5 Series E60 528xi (N52K) SAL
31 50 001
Removing and installing/replacing front
differential
Warning!
Danger to life!
Secure engine in installation position to prevent it from falling
down.
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off hydraulic lines with plugs.
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Secure engine in installation position
•
Disconnect pressure line from vane pump
•
Disconnect return line from cooling coil
•
Drain and dispose of front differential oil
•
Remove left output shaft
•
Press right output shaft approx. 6 to 7 cm out of front
differential
•
Remove propeller shaft from front differential
•
Replacement only:
-
Replace front axle output flange on transfer box
Note: Replace the output flange to ensure a clean seal
on the transfer case.
•
Lower front axle carrier
Important!
Grip front differential firmly while releasing last bolt in order to
avoid damage caused by the differential falling.
RA Removing and installing/replacing front differential
BMW AG - TIS
21.02.2013 14:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
