5 Series E60 528xi (N52K) SAL
![background image](/bmw/5_Series_E60/528xi_N52K_SAL/page-1284002.png)
Disconnect plug connection (1).
Note:
If necessary, carefully heat fogging sensor (2) with a hot air
blower to approx. 40-60
°
C.
Lift off fogging sensor (2) with special tool
00 9 317 and slowly
pull off from windshield.
Installation:
Bonding surface must be dry and free of dust and grease.
Clean bonding surface with adhesive remover (sourcing
reference: BMW Parts Service).
After cleaning, do not touch bonding surface with bare hands.
Pull off protective film completely from fogging sensor (3).
Place mounting template (1) as pictured on rain sensor (2).
Press fogging sensor (3) in direction of arrow with a contact
pressure of
≥
15 N/cm
2
onto inside of windshield.
Note:
Firm thumb pressure attains approx. 30 N/cm
2
.
Remove mounting template (1) carefully from fogging
sensor (3).
RA Replacing fogging sensor
BMW AG - TIS
21.02.2013 23:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -