5 Series E60 530d (M57TU) SAL
11 14 151
Replacing crankshaft seal (M57TU)
Necessary preliminary tasks:
•
Remove transmission.
•
Drain engine oil.
•
Remove flywheel.
Unfasten oil sump screws on transmission end.
Loosen oil pan.
Release screws (1).
Release screw (2), remove crankshaft sensor (3) in direction of
arrow.
Note:
Check sump gasket for damage after removing end cover.
If necessary, remove oil sump and replace oil sump gasket.
Note:
Illustration does not show oil sump.
Note:
When fitting the end cover with radial seal on the crankshaft, it
is only permitted to use the "support bushing (1)" as an
installation tool.
Lubricate contact face of crankshaft.
Important!
Push on end cover with support bushing (1) straight and
without tilting sideways.
Insert all screws and tighten down end cover.
Note:
RA Replacing crankshaft seal (M57TU)
BMW AG - TIS
21.02.2013 10:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
