5 Series E60 530d (M57TU) SAL
Installation:
Apply a thin coat of petroleum jelly to sealing surfaces of sealing
rings (1).
Insert sealing rings (1) in intake snorkel.
Disconnect plug connection (2) from air-mass flow sensor.
Unfasten screws (1).
Remove air-mass sensor.
Tightening torque 13 62 7AZ
.
Read fault memory of DDE control module.
Check stored fault messages.
Rectify faults and clear fault memory.
Assemble engine.
Important!
EU4 only.
Reset adaptations, quantity mean value adaptation
Check function of DDE.
RA Removing and installing/replacing air mass sensor (M57TU)
BMW AG - TIS
21.02.2013 12:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
