5 Series E60 530d (M57TU) SAL
Important!
Risk of breakage!
Carefully raise connecting cover. In so doing, do not pull
excessively on connecting piece of fuel feed.
Installation:
When installing connecting cover, make sure that lug (1) in
opening (2) engages fuel tank.
During torque tightening, notch (3) on screw cap can be clearly
heard and felt to engage toothed segment (4) on fuel tank.
Secure a cable to hose pack through left service opening in tank.
The cable facilitates reinstallation of the hose pack.
Carefully remove right sensor unit from fuel tank.
Important!
Surge chamber is filled with fuel.
Drain surge chamber through upper opening (1). Catch fuel in
a suitable container.
Feed hose pack out of fuel tank.
Installation:
The new sensor unit is supplied with a plastic cover over the hose
pack.
Secure the cable pulled through the tank during removal to the
eyelet on the plastic cover.
Carefully feed hose pack through fuel tank using cable.
Important!
The lines on the connection are turned to the sensor unit as
the hose pack is fed in.
Turn sensor unit in the same direction of rotation and align.
It is absolutely essential to avoid kinking the hoses.
Remove the plastic cover after feeding in the hose pack.
Replacing fuel level sensor:
Unlock and disconnect plug (2).
Release catches (1) and pull fuel level sensor out of unit.
RA Removing and installing/replacing fuel gauge sensor (complete right sensor unit)
BMW AG - TIS
21.02.2013 12:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
