5 Series E60 530d (M57TU) SAL
23 12 059
Replacing radial shaft seal for output flange
(GS6-53BZ/DZ G-transmission)
Special tools required:
•
23 0 020
•
23 0 200
•
23 2 320
•
23 3 210
•
23 3 230
•
33 1 150
•
33 1 154
Important!
After completion of work, check transmission oil level.
Use only approved transmission oil.
Failure to comply with this instruction will result in serious
damage to the transmission.
Necessary preliminary tasks:
•
Unflange propeller shaft from transmission and tie up to one
side.
Tasks are described in Removing propeller shaft.
Brace output flange with special tool 23 0 020 .
Release collar nut with special tool 23 2 320 .
Release E90,91 M57T2, E60S85 with special tool 23 0 200 .
Installation:
Mark flange with thermo pin and heat to min. 80
°
- 100
°
.
Warning!
Scalding hazard! Fit flange wearing suitable protective gloves
only!
Important!
RA Replacing radial shaft seal for output flange (GS6-53BZ/DZ G-transmission)
BMW AG - TIS
21.02.2013 13:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
