5 Series E60 530d (M57TU) SAL
Version with Dynamic Drive:
Remove bottom right wheel arch trim.
Release nuts (1, 2).
Tightening torque (1): 32 41 3AZ.
Tightening torque (2): 37 14 13AZ.
Version with active steering:
Disconnect plug connections (1, 2).
Expose wiring harness (3) up to front axle carrier.
Important!
Guide spring struts with your hand when lowering and raising
in order to avoid damaging the wheel arches.
After lowering, the spring struts must be aligned to the front
axle carrier and secured in such a way that the ball joints of
the control arms, tension struts and tie rod ends are not
damaged.
Remove both spring struts from spring strut dome.
Support front axle carrier, release from engine carrier and carefully
lower with spring struts.
RA Removing and installing complete front axle (with spring strut shock absorber)
BMW AG - TIS
21.02.2013 14:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
