5 Series E60 530d (M57TU) SAL
Version with Dynamic Drive:
Draw off and dispose off hydraulic fluid from fluid reservoir.
Remove bottom right wheel arch trim.
Release nut (1) for Dynamic Drive return line.
Tightening torque 37 14 21AZ
.
Release nut (2) for Dynamic Drive pressure line.
Tightening torque 37 14 13AZ
.
Release nuts (3) for pressure lines to front axle oscillating motor.
Tightening torque 37 14 13AZ
.
Version with active steering:
Disconnect plug connections (1, 2).
Expose wiring harness (3) up to front axle carrier.
Warning!
Danger of injury!
Failure to comply with the following instructions may result
in the vehicle slipping off the lifting platform and critically
injuring other persons.
When supporting components, make sure that
•
the vehicle can no longer be raised or lowered
•
the vehicle does not lift off the locating plates on the
lifting platform
If necessary, position special tool 00 2 040 with a 2nd person
helping on workshop jack 00 2 030 .
Insert special tool 31 4 012 into corresponding receptacles of
special tool 00 2 040 .
Align special tool 00 2 040 to front axle carrier.
Note:
Make sure when raising that the special tools 31 4 012 are
correctly inserted in the rear recesses on the front axle carrier.
Support front axle carrier in rear area by raising special tool
00 2 040 .
Position special tool 33 3 274 on floor jack mounting.
RA Lowering/raising front axle carrier
BMW AG - TIS
21.02.2013 14:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
