5 Series E60 530d (M57TU) SAL
Unscrew nuts.
Remove shims.
If necessary, remove bracket (not shown in illustration).
Installation:
Replace self-locking nuts.
Tightening torque 32 41 9AZ
.
Note:
If necessary, raise and/or turn fluid reservoir in order to gain better
access to plug connection and hose clamps.
If necessary, disconnect plug connection at level switch.
Remove hose clamps if necessary with special tool 32 1 260 .
Disconnect suction and cooler return lines from fluid reservoir,
check and if necessary replace.
Lift out fluid reservoir.
Replacement:
If necessary, remove level switch.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
Version with Dynamic Drive:
•
If necessary, carry out initial Dynamic Drive operation
RA Removing and installing / replacing fluid reservoir for power steering with Dyna
BMW AG - TIS
21.02.2013 15:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
