5 Series E60 530d (M57TU) SAL
Remove stabilizer link from swinging arm.
E60: Remove spring strut shock absorber from wheel carrier.
E61: Remove rear shock absorber from swinging arm .
Raise wheel carrier for feeding output shaft out and in with
workshop jack approx. 20 mm.
Important!
Risk of damage!
Do not drive output shaft out of drive flange with an impact
tool.
Press output shaft out of drive flange and remove towards centre
of vehicle.
After installation:
•
Check that output shaft is correctly seated in rear differential.
•
E61: Activate and fill air suspension system
RA Removing and installing / replacing right output shaft
BMW AG - TIS
21.02.2013 16:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
