5 Series E60 530d (M57TU) SAL
33 41 000
Replacing drive flange on left/right rear axle
shaft
Special tools required:
•
33 2 116
•
33 2 160
•
33 2 201
•
33 4 200
Remove rear wheel.
Important!
Expand turning lock sufficiently to avoid damaging thread
when releasing collar nut.
Release collar nut, activate handbrake for this purpose.
Installation:
Replace collar nut, oil collar nut/wheel bearing contact surface
lightly and tighten down.
No oil permitted on thread of shaft journal or collar nut.
Tightening torque 33 41 3AZ
.
Secure collar nut by positive peening on flat areas of output shaft.
Remove brake disk.
Force drive flange with special tools 33 2 116 / 33 2 201 ,
33 2 160 , 33 4 200 and 5 wheel bolts out of wheel bearing.
Note:
Rounded inside edge of special tool 33 2 160 must point to drive
flange.
RA Replacing drive flange on left/right rear axle shaft
BMW AG - TIS
21.02.2013 16:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
