5 Series E60 530d (M57TU) SAL
37 20 001
Removing and installing/replacing DYNAMIC
DRIVE valve block
Note:
In a warranty case you must always provide a fault memory
printout, even where there is no fault memory entry, with the
defective part.
Warning!
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Close off pipe connections with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Remove bottom right wheel arch trim
•
Partially remove right underbody paneling
RA Removing and installing/replacing DYNAMIC DRIVE valve block
BMW AG - TIS
21.02.2013 17:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
