5 Series E60 530d (M57TU) SAL
51 23 211
Removing and installing/replacing cable for
front engine hood locks (to passenger
compartment)
Necessary preliminary tasks:
•
Disconnect cable for hood/bonnet locks
•
Remove lower section of microfilter housing
•
Remove trim panel for pedal assembly
•
Remove footwell side trim panel on A-pillar
Release screws (1).
Remove fixture (2) and feed out Bowden cable (3).
Feed Bowden cable (1) out of grommet (2).
Carefully feed Bowden cable (1) with grommet (3) out of vehicle
interior.
Important!
Make sure grommets (2 and 3) are correctly seated (water
ingress).
Installation:
Lay Bowden cable (1) without kinks.
RA Removing and installing/replacing cable for front engine hood locks (to passenge
BMW AG - TIS
21.02.2013 20:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
