bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

2 RA Removing And Installing_replacing Lock Element (lock Cylinder) For Rear Lid > < 1 RA Adjusting Rear Lid Lock (lower Section Of Rear Lid Lock)
Page 2
background image

Note:

Adjusting lower section of rear lid lock:

Close rear lid.

This enables the lower section of the rear lid lock to adjust itself
correctly.

Open rear lid.

Tighten down screws on lower section of rear lid lock.

Tightening torque  51 24 6AZ

 (E60, E63, E64).

Tightening torque  51 24 2AZ

 (E82, E88, E90, E92).

Check adjustment of rear lid and rear lid lock, repeating
adjustment if necessary.

Unscrew detent buffer until closed rear lid abuts against left/right
detent buffers.

Important!

The rear lid must not be higher than the side panels,
otherwise there is preload on height adjustment!

RA  Adjusting rear lid lock (lower section of rear lid lock)

BMW AG - TIS

21.02.2013  20:03

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 2 -

2 RA Removing And Installing_replacing Lock Element (lock Cylinder) For Rear Lid > < 1 RA Adjusting Rear Lid Lock (lower Section Of Rear Lid Lock)