5 Series E60 530d (M57TU) SAL
61 31 020
Removing and installing/replacing ignition
starter switch
Necessary preliminary tasks:
•
Move ignition lock to key position 0 (stop)
•
Remove lower section of steering column trim
Important!
Before removing ignition starter switch (1), secure inner shaft
against turning:
Insert a M2.5*8 screw in bore (2).
Installation:
Remove screw in bore (2).
Release screws (1), tightening torque 61 31 1AZ
.
Installation:
Secure screws (1) with sealing paint.
Important!
Carefully unlock and disconnect associated plug connection
for ribbon cable.
Replace the ribbon cable if damaged.
The ribbon cable leads to the control unit for the Car Access
System.
Remove ignition starter switch (2).
RA Removing and installing/replacing ignition starter switch
BMW AG - TIS
21.02.2013 23:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
