5 Series E60 530d (M57TU) SAL
61 31 382
Replacing level switch for coolant
Warning!
Danger of scalding!
Only perform this work after engine has cooled down.
Release screws (1).
Unlock plug connection for coolant level switch (4) and
disconnect.
Pull coolant expansion tank (2) in direction of arrow out of
grommet (3) underneath.
Installation:
Make sure coolant expansion tank (2) is correctly seated in
grommet (3).
If necessary, replace grommet (3).
Important!
Do not damage connected water hoses.
Reposition coolant expansion tank (2) as far as possible until
coolant level switch (4) forms the highest point. This will
prevent coolant from escaping on opening.
If necessary, catch escaping coolant and feed back in later.
Note:
For purposes of clarity, illustration shows coolant expansion
tank (2) removed.
Turn coolant level switch (1) in direction of arrow, pull upwards
out of coolant expansion tank (2) and remove.
RA Replacing level switch for coolant
BMW AG - TIS
22.02.2013 00:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
