5 Series E60 530Li (N52) SAL
61 35 015
Removing and installing (replacing) control
unit for Car Access System
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Remove trim panel for pedal assembly.
Unfasten plug connection (2) and disconnect.
Important!
Carefully unlock and disconnect associated plug connection
for ribbon cable (1).
Replace ribbon cable (1) if
•
plug connection for ribbon cable (1) is damaged
•
control unit for Car Access System (3) is replaced
The ribbon cable leads to the ignition starter switch.
Release screw (4) and remove control unit for Car Access
System (3) in direction of arrow.
RA Removing and installing (replacing) control unit for Car Access System
BMW AG - TIS
22.02.2013 05:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -