5 Series E60 530Li (N52K) SAL
12 13 511
Replacing ignition coils (N52, N52K, N51)
Necessary preliminary tasks:
•
Read out fault memory of DME control unit.
•
Check stored fault messages
•
Switch off ignition
•
Remove ignition coil cover
Unlock plug retainer of ignition coil (1) and disconnect plug.
Pull ignition coil (1) up and out.
This procedure is applicable to all ignition coils.
Installation:
Check that rubber seal of ignition coil (1) is correctly seated.
Installation:
Push plug (1) with plug retainer (2) open onto ignition coil.
Carefully close plug retainer (2) in direction of arrow.
RA Replacing ignition coils (N52, N52K, N51)
BMW AG - TIS
21.02.2013 17:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
