5 Series E60 530xd (M57T2) SAL
•
If necessary, disconnect vacuum line of electrically operated
valve from Y-distributor and expose
If necessary, position special tool 00 2 040 with a 2nd person
helping on workshop jack.
Insert special tool 31 4 070 into corresponding
receptacles 1 and 2 of special tool
00 2 040 .
Insert special tool 31 4 060 with marking 1 into receptacle 4
of special tool 00 2 040 .
Insert special tool 31 4 060 with marking 2 into receptacle 3
of special tool 00 2 040 .
Warning!
Danger of injury!
Failure to comply with the following instructions may result
in the vehicle slipping off the lifting platform and critically
injuring other persons.
When supporting components, make sure that
•
the vehicle can no longer be raised or lowered
•
the vehicle does not lift off the locating plates on the
lifting platform
Align special tool 00 2 040 to front axle carrier.
If necessary, lower special tool 33 3 274.
Support front axle carrier by raising special tool 00 2 040 .
Note:
Make sure when raising that special tools 31 4 070 and
31 4 060 are correctly inserted in the front or rear recesses on
the front axle carrier.
M57T2:
Note:
This bracket is only installed on the left side.
Release bolts (1).
Tightening torque 31 10 13AZ
.
RA Lowering/raising front axle carrier (AWD)
BMW AG - TIS
22.02.2013 01:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
