5 Series E60 530xi (N52K) SAL
32 31 102
Replacing sleeve for steering spindle (4WD)
Important!
Do not kink floor panelling under any circumstances!
After installation:
•
Carry out steering angle sensor adjustment
Necessary preliminary tasks:
•
Remove lower section of steering spindle
•
Remove accelerator pedal module
•
Take floor panelling out of bulkhead and secure
Release nut (1) and press cable duct a little to one side.
Remove sleeve (2) from bulkhead.
Installation:
Grease/spray sleeve (2) from outside with silicone grease.
Align sleeve (2) by way of arrow to bulkhead and insert.
Check seating of sleeve (2), correct if necessary.
RA Replacing sleeve for steering spindle (4WD)
BMW AG - TIS
22.02.2013 03:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
