5 Series E60 530xi (N53) SAL
Support swivel bearing with workshop jack and a suitable
mounting.
Release nut (1) and remove holder (2).
Pull out bolt (3) towards front.
Spread swivel bearing with special tool 31 2 230 .
Lower workshop jack and remove swivel bearing.
Installation:
Keep press fit of swivel gearing and spring strut in lower area
clean and free from oil and grease.
Spread swivel bearing with special tool 31 2 230 , align by
means of gap to positioning pins on back of spring strut and raise
as far as it will go.
Replace self-locking nut.
Tightening torque 31 31 3AZ
.
Replacement:
Modify guide joint.
Modify dust sleeve (1).
Modify brake guard plate (2).
Installation:
Install new wheel bearing.
Draw in drive flange.
After installation:
•
Replacement only: Perform chassis alignment check
RA Removing and installing/replacing left or right swivel bearing (AWD)
BMW AG - TIS
22.02.2013 03:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -