5 Series E60 535d (M57T2) SAL
11 13 000
Removing and installing, sealing or replacing
oil sump (M57T2)
Necessary preliminary tasks:
•
Remove acoustic cover
•
Remove radiator cowl
•
Remove engine underguard at front/rear
•
Secure engine in installation position
•
Drain off engine oil
•
Lower front axle support
Note:
There is no need to perform a front axle alignment check.
Release screws (1).
Release screw (2).
Remove oil measuring tube (3).
Disconnect plug connection (4) on oil level sensor.
Release screws (1).
Release screws (2).
Release screws along line (3).
Installation:
Tightening torque 11 13 2AZ
.
Tighten down all screws diagonally and evenly.
Move oil pan backwards.
RA Removing and installing, sealing or replacing oil sump (M57T2)
BMW AG - TIS
22.02.2013 01:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -