5 Series E60 535d (M57T2) SAL
51 11 050
Removing and installing/replacing carrier for
front bumper trim
Necessary preliminary tasks:
•
Remove front bumper trim
Detach wiring harness (1) from impact absorber (2).
If necessary, disconnect plug connections from add-on parts on
carrier.
Version with ACC:
If necessary, remove ACC sensor.
Version with headlight washer system:
If necessary, disconnect line (2) on right from washer fluid
reservoir coming from T-distributor (1).
Important!
Carrier must not be separated from deformation elements.
Note:
The operation is described on the left side; proceed in the same
way for the right side.
Release screw (1).
If necessary, drill out rivets (3).
Release screws (2).
Remove carrier (4) with deformation element towards front.
RA Removing and installing/replacing carrier for front bumper trim
BMW AG - TIS
22.02.2013 09:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -