5 Series E60 535i (N54) SAL
Release screws.
Remove transmission support block.
Tightening torque 22 32 2AZ
.
-
Remove propeller shaft from transmission.
-
Release centre bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Note:
Pressure line of clutch slave cylinder remains connected.
Important!
Slowly relieve tension on clutch slave cylinder otherwise air is
drawn in through sealing sleeve.
Release nuts and remove clutch slave cylinder.
Tightening torque 21 52 5AZ
.
Lever out retainer (1).
Disengage shift rod (2).
Installation:
Grease shift rod.
Grease, refer to BMW Service Operating Fluids.
Make sure shims (3) are in correct position.
RA Removing and installing transmission (GS6-53DZ) N54
BMW AG - TIS
22.02.2013 03:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
