5 Series E60 535i (N54) SAL
Release screws (1, 2) and remove power steering pump towards
front.
Installation:
Observe installation sequence at end of document.
Release banjo bolt (2) and detach pressure line (1) from vane
pump.
Installation:
Replace all sealing rings.
Tightening torque 32 41 3AZ
.
Release hose clamp (3) and detach suction line (4) from vane
pump.
Remove vane pump.
Installation:
Markings (5) on suction line and vane pump connection must
match up.
Installation sequence:
1.
Insert screws (1, 2) (do not tighten down)
2.
Tighten first screw (2) and then screws (1) to 2 Nm
3.
Tighten down screws (1)
Tightening torque 32 41 1AZ
.
4.
Release screw (2) and check screw fastening point for gap
freedom
5.
Tighten down screw (2)
Tightening torque 32 41 1AZ
.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
RA Removing and installing/replacing vane pump for power steering (N54)
BMW AG - TIS
22.02.2013 05:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
