5 Series E60 535xi (N54) SAL
12 41 020
Removing and installing/replacing starter
motor (N54)
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Switch off ignition
•
Disconnect battery negative lead
•
Remove intake air manifold
Unlock plug (1) and remove.
Release nut (2) and disconnect battery positive lead (3).
Tightening torque 12 42 2AZ
.
Release bolts and remove starter motor.
Tightening torque 12 41 1AZ
.
Installation:
Check starter pinion and ring gear for damage, replace starter
motor if necessary.
RA Removing and installing/replacing starter motor (N54)
BMW AG - TIS
22.02.2013 06:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -