5 Series E60 535xi (N54) SAL
Important!
Aluminium-magnesium materials.
No steel screws/bolts may be used due to the threat of
electrochemical corrosion.
A magnesium crankcase requires aluminium screws/bolts
exclusively.
Aluminium screws/bolts must be replaced each time they are
released.
The end faces of aluminium screws/bolts are painted blue for
the purposes of reliable identification.
Jointing torque and angle of rotation must be observed
without fail (risk of damage).
Necessary preliminary tasks:
•
Disconnect battery negative lead
•
Remove underbody protection at front and rear
•
Remove reinforcement plate
Important notes on installation are described in this work step
•
Remove complete exhaust system
Remove heat shields (1) and (2) and bracket.
Installation:
Release aluminium screw on right next to cable retaining plate
with special tool 00 9 010 .
Aluminium screws must be replaced. Tightening torque
24 00 2AZ
.
RA Removing and installing automatic transmission (6HP19Z AWD) N54
BMW AG - TIS
22.02.2013 08:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
