5 Series E60 540i (N62TU) SAL
Replacement only:
When replacing rocker arms (1) on inlet side:
Rocker arms have new tolerance classes and must be assigned to
the old tolerance classes and fitted in the same position.
Old 1 = new 2A
Old 2 = new 2A
Old 3 = new 2B
Old 4 = new 2B
Installation:
Installation of rocker arms is described separately from removal.
Clean all bearings and cams of inlet camshaft and lubricate with
engine oil.
Ends of compression rings (1) point upwards.
Make sure compression rings (1) are engaged at ends.
Install rocker arms (1) on inlet side.
Important!
Rocker arms (1) slip slightly when bearing bracket is fitted.
Make sure rocker arms (1) are secured as illustrated on
hydraulic valve clearance compensating elements and on
valves.
Align rockers (1) straight.
RA Removing and installing/replacing rocker arms on right inlet side (N62 from 9/03
BMW AG - TIS
22.02.2013 09:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -