5 Series E60 540i (N62TU) SAL
32 43 010
Removing and installing/replacing control
unit for active front steering
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Remove right entrance strip
•
Remove right front seat
•
Disconnect battery negative lead
•
If necessary, remove front right floor mat
•
Remove side trim in front right footwell
Important!
Do not kink floor panelling under any circumstances!
Fold back front right floor trim.
Remove kickplate in footwell in front of and next to control unit; if
necessary, cut along specified lines with knife and secure later
with adhesive tape.
Release screws (1) and lay grounding cable to one side.
Installation:
Secure grounding cable as illustrated to retaining plate.
Tightening torque 32 43 1AZ
.
RA Removing and installing/replacing control unit for active front steering
BMW AG - TIS
22.02.2013 23:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -