5 Series E60 545i (N62) SAL
Installation:
Replace seal (1).
Align gasket (1) loosely in cover groove. Starting at corner radii,
secure gasket (1) in cover groove and press into groove so that it
is free of tension.
Installation:
Make sure sliding rails are correctly seated when mounting on
cylinder head.
Installation:
Replace spark plug domes.
Coat rubber seals on spark plug dome (1) with anti-friction rubber
coating.
Installation:
Install spark plug domes in cylinder head.
When fitting cylinder head cover:
Align spark plug domes to cylinder head cover.
Installation:
Clean seal residue from sealing surfaces.
Coat contact surfaces of joint with Drei Bond 1209 (refer
to BMW Parts Service).
RA Removing and installing/sealing right cylinder head cover (N62/N62TU)
BMW AG - TIS
22.02.2013 11:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
