5 Series E60 545i (N62) SAL
Do not drive on flange.
Secure collar nut with Loctite 243.
-
Loctite 243: BMW Parts Service.
-
Tightening torque:23 21 1AZ
.
Detach output flange (1) with special tool 33 1 150 and adapter
plate 33 1 154 from output shaft.
Release screw on special tool 23 3 210 .
Slide special tool 23 3 210 over output shaft and screw into
sealing ring firmly.
Insert screw into special tool 23 3 210 again and continue
turning until sealing ring is pulled out of transmission housing.
If necessary, remove ring spring of sealing ring.
RA Replacing radial shaft seal for output flange (GS6-53BZ/DZ G-transmission)
BMW AG - TIS
22.02.2013 14:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -