5 Series E60 545i (N62) SAL
Remove heat shield(s).
Disconnect hydraulic lines from power steering gear and front axle
carrier.
Remove left engine mount/bracket and right engine mount and if
necessary remove with vacuum lines from front axle carrier.
Remove power steering gear.
Remove vehicle jack support.
Take front axle carrier down and set down on a suitable surface.
Installation:
Use previous front axle carrier as a template for modifying or
replacing small parts.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment/adjustment for
active steering
•
If necessary, carry out initial Dynamic Drive operation
RA Replacing front axle carrier
BMW AG - TIS
22.02.2013 15:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -