5 Series E60 545i (N62) SAL
Release banjo bolt (1) and detach pressure line (2) from power
steering pump.
Installation:
Replace all sealing rings (D).
Make sure hydraulic line is laid without tension and with sufficient
spacing to adjoining components.
Tightening torque 32 41 3AZ
.
Expose pressure line up to cutting line on front axle carrier.
Release banjo bolt (1) and remove pressure line (2).
Installation:
Make sure hydraulic line is laid without tension and with sufficient
spacing to adjoining components.
Tightening torque 32 41 10AZ
.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
RA Replacing pressure line for power steering with Dynamic Drive (N62, N62TU) (from
BMW AG - TIS
22.02.2013 16:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
