5 Series E60 M5 (S85) SAL
Important!
VANOS high-pressure pump up to 12/05
Clamping rail (1) of oil pump without visible sleeve (see arrow).
On the VANOS high-pressure pump up to 12/05, it is necessary to
check the pretension on the oil pump chain.
Important!
Spacer plates are only required if the oil pump chain
demonstrates excessive tension.
Low teeth of VANOS high-pressure pump before 12/05.
Tie back VANOS high-pressure line (2) with cable tie (1).
Install spacer plate (3).
Install spacer (4).
Position VANOS high-pressure pump (3) on crankcase.
Insert screws (2).
Slide VANOS high-pressure pump in direction of crankshaft until
gearwheel (3) has slight play.
Initially tighten VANOS high-pressure pump with special tool
11 4 350 to 2 Nm .
Mount special tool 11 6 254 on crankcase.
Secure special tool 11 6 252 with magnetic base to special tool
11 6 254 .
RA Removing and installing / replacing VANOS high-pressure pump (S85)
BMW AG - TIS
22.02.2013 16:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
