5 Series E60 M5 (S85) SAL
Installation:
Both thrust bearing plates (1) on the VANOS adjustment unit can
be rotated.
Both thrust bearing plates (1) must be retracted.
Clean sealing surface (2).
Replace seal.
Installation:
VANOS adjustment unit is marked to avoid being mixed up.
The lettering EIN (1) must point to the inlet camshaft.
Cylinder assignment (2), cyl. 1-5 or 6-10.
Important!
Risk of mixing up parts!
Insert seal.
Position VANOS adjustment unit (4) with both outer bolts (1).
Both VANOS gears (2) are extended.
Align thrust bearing plates (3).
Push VANOS adjustment unit forwards until thrust bearing
plates (3) rest against VANOS gears (2).
Installation:
There is a visible gap of approx. 8 mm between VANOS
adjustment unit and cylinder head.
Insert hexagon socket screws without washers (1) and join.
Release screws without washers (1) through 90
°
again.
Important!
All screws with and without washers must be released
through 90
°
.
Screw in bolts (2) of VANOS adjustment unit uniformly in 1/2
turns.
Installation:
Both outer sleeves rotate clockwise and retract approx. 8 mm.
Both inner sleeves with elongated hole must rotate
counterclockwise (see arrow).
RA Removing and installing / replacing right inlet VANOS gear (S85)
BMW AG - TIS
22.02.2013 16:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
