5 Series E60 M5 (S85) SAL
Insert seal.
Position VANOS adjustment unit (4) with both outer bolts (1).
Both VANOS gears (2) are extended.
Align thrust bearing plates (3).
Push VANOS adjustment unit (4) forwards until thrust bearing
plates (3) rest against VANOS gears (2).
Installation:
There is a visible gap of approx. 8 mm between VANOS
adjustment unit (4) and cylinder head.
Insert hexagon socket screws without washers (1) and join to
10 Nm .
Release hexagon socket screws without washers (1) through 90
°
again.
Important!
All hexagon socket screws with and without washers must be
released through 90
°
.
Screw in bolts (2) of VANOS adjustment unit uniformly in 1/2
turns.
Installation:
Both outer sleeves rotate clockwise and retract approx. 8 mm.
Both inner sleeves with elongated hole must rotate
counterclockwise (see arrow).
Installation:
Check seal for correct seating.
Secure VANOS adjustment unit with screws (1 and 2).
RA Removing and installing / replacing right exhaust VANOS gear (S85)
BMW AG - TIS
22.02.2013 16:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
