5 Series E60 M5 (S85) SAL
Release screws (1).
Remove oil pump (2).
Installation:
Check dihedron on oil pump shaft (3) for damage, replace oil
pump if necessary.
Clean thread of oil pump shaft (3) with suitable means.
Important!
Two different versions of oil pump are fitted with different
tightening torques.
Place sprocket wheel (1) with chain (3) on oil pump shaft (2).
Rotate oil pump shaft (2) with a screwdriver in direction of arrow
until dihedrons of oil pump shaft and sprocket wheel are flush.
Coat thread (2) with Loctite 648 (refer to BMW Parts Service).
Tighten nut (1).
Tightening torque: 11 41 1AZ
.
Installation:
Check tensioning travel of chain tensioner.
Slide caliper gauge (1) as far as it will go on reverse side of
sliding rail.
Adjust caliper gauge (1) to tensioning rail.
Note:
Checking dimension: 72.5 to 80 mm.
If the dimension 80 mm is exceeded, shims must be fitted on the
VANOS high-pressure pump.
RA Removing and installing / replacing oil pump (S85)
BMW AG - TIS
22.02.2013 16:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
