5 Series E60 M5 (S85) SAL
11 78 533
Replacing right oxygen control sensor (S85)
Special tools required:
•
11 7 030
•
11 9 150
Warning!
Scalding hazard!
Only perform these tasks after exhaust system has cooled
down.
Necessary preliminary tasks:
•
Read out fault memory in Digital Motor Electronics (DME).
•
Remove transmission underbody protection.
•
Remove bottom right wheel arch trim.
Remove oxygen control sensor (1) with special tools 11 7 030
and 11 9 150 .
Installation:
When using special tools 11 7 030 and 11 9 150 , 47 Nm on
torque wrench scale corresponds to an actual tightening torque of
50 Nm.
If the oxygen control sensor is reused, apply a thin and even coat
of Never Seez Compound (refer to BMW Parts Service) to the
thread only.
RA Replacing right oxygen control sensor (S85)
BMW AG - TIS
22.02.2013 17:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
