5 Series E60 M5 (S85) SAL
Release nuts with special tool 34 3 171 .
Remove throttle valve assemblies 6 - 10.
Important!
Read and comply with notes on correct installation (see
below).
Removing throttle valve assemblies 1 - 5:
Release screws and detach injection pipe (1) from throttle valve
assemblies.
Remove pull rod (2).
Unlock plug (1) and remove.
Release wiring harness from retaining clip (2).
Release nut (3) and disconnect starter positive lead.
Tightening torque 12 52 2AZ
.
Unfasten nut.
Tightening torque 12 52 3AZ
.
Carefully raise cable duct (4) slightly.
Release nuts with special tool 34 3 171 .
Remove throttle valve assemblies 1 - 5.
RA Removing and installing/sealing throttle valve assembly (S54)
BMW AG - TIS
22.02.2013 17:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
