5 Series E60 M5 (S85) SAL
Release screws (1).
Tightening torque 23 41 24/ 26AZ
Installation:
Do not replace screws.
Release screws (1).
Tightening torque 23 41 31AZ
.
Installation:
-
Clean inside surface (1) of pump block with paper towel.
-
Check O-ring (2) for damage.
O-ring may only be replaced if it is damaged!
-
Coat O-ring (2) with petroleum jelly before installing electric
motor
Bend open retaining clip (1) a little.
Turn electric motor (2) in direction of arrow, slide towards rear
and remove.
Installation:
To facilitate installation, coat rubber sleeve on pressure
accumulator with petroleum jelly.
RA Replacing electric motor on hydraulic pump (GS7S47BG SMG)
BMW AG - TIS
22.02.2013 19:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
