5 Series E60 M5 (S85) SAL
Remove trim panel for pedal assembly.
When reinstalling lower section of steering spindle: mark
installation position of universal joint in relation to steering column.
Switch on ignition.
Turn steering wheel approx. 45
°
, hold securely and release
clamping screw (1).
Turn steering wheel back and remove ignition key.
Detach lower section of steering spindle from steering column.
Installation:
Clean thread to remove all remnants of screw securing adhesive.
Replace clamping screw.
Clamping screw must rest in groove of steering column.
Tightening torque 32 31 1AZ
.
After installation:
•
Turn steering wheel in both directions to full lock. The airbag
warning lamp must not light up in the process.
•
Carry out steering angle sensor adjustment/adjustment for
active front steering
•
Check directional stability of car
RA Removing and installing / replacing lower section of steering spindle
BMW AG - TIS
22.02.2013 20:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
