5 Series E60 M5 (S85) SAL
33 32 071
Replacing one upper control arm
Important!
The control arm to wheel carrier connection has been
changed from a conical seat to a ball seat! Spare parts are
offered for both variants.
To ensure a correct bolt connection, check before installing
the control arm whether the seat for the control arm matches
the seat for the wheel carrier.
Variants:
A
Conical seat
B
Ball seat
Note:
If the control arm is detached from the rear axle carrier, it is
necessary after reinstallation to carry out a wheel/chassis
alignment check.
Necessary preliminary tasks:
•
Remove rear wheel.
•
E61: Deactivate and empty air spring system
Shown on vehicle at rear right:
Unclip line for pulse generator (1) from holder (2).
Only on right side: Unclip line for brake pad wear sensor (3) from
holder (2).
RA Replacing one upper control arm
BMW AG - TIS
22.02.2013 21:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
