bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

2 RA Replacing All Rubber Mounts For Rear Axle Carrier > < 7 RA Removing And Installing _ Replacing Left Or Right Tension Strut (on Rear Axle) (
Page 1
background image

33 33 001

Replacing left or right rear axle carrier
compression strut

Important!

Observe safety instructions for raising the vehicle

Driving without tension and compression struts is not
permitted!

 

Risk of damage!

The rear axle carrier must be supported at the front if both
compression struts have to be replaced!

Necessary preliminary tasks:

If necessary, remove rear tension strut

Remove tank cover

Version with Dynamic Drive: Disconnect pressure lines for

oscillating motor of rear axle from tension strut.

Release screws (2).

Tightening torque  33 32 17AZ

.

Release bolt (1) and remove compression strut.

Secure rear axle carrier by inserting bolt (1).

Installation:

Check threads for damage; if necessary, repair with Helicoil thread
inserts.

Tightening torque 33 33 3AZ

.

RA  Replacing left or right rear axle carrier compression strut

BMW AG - TIS

22.02.2013  21:08

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

2 RA Replacing All Rubber Mounts For Rear Axle Carrier > < 7 RA Removing And Installing _ Replacing Left Or Right Tension Strut (on Rear Axle) (