5 Series E60 M5 (S85) SAL
34 21 320
Removing and installing or replacing both
rear brake discs (S85)
Necessary preliminary tasks:
•
Remove wheels
•
If necessary, remove and clean brake pads
After completing work:
•
Adjust handbrake.
•
Read and comply with notes on braking in new brake discs /
brake pads.
Important!
If the thickness of the brake discs drops below the minimum
brake disc thickness (MIN TH ), then the brake discs must be
replaced.
Always replace brake discs in pairs.
If the brake discs are replaced, you must also fit new brake
pads.
The brake discs of M models are tied to the direction of travel:
The uneven part number denotes the left brake disc, the even
part number the right brake disc!
Release screws (1), remove brake caliper and tie up.
Note:
Brake hose remains connected.
Installation:
Tightening torque 34 21 3AZ
.
Release screws (1) and remove brake disc (2).
Important!
To release brake disc: Do not under any circumstances strike
friction ring with a hammer or similar! If necessary, carefully
tap on base of brake disc chamber with a rubber mallet.
Installation:
Make sure contact surfaces between wheel hub and brake
disc are absolutely clean.
Replace screws.
RA Removing and installing or replacing both rear brake discs (S85)
BMW AG - TIS
22.02.2013 21:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -