5 Series E60 M5 (S85) SAL
34 51 527
Removing and installing/replacing hydraulic
unit for DSC (S85)
Necessary preliminary tasks:
•
Read and comply with General Information.
•
Remove front left wheel arch trim.
•
Remove front left support.
After completing work: Bleed braking system
Installation:
After reinstalling the hydraulic unit, carry out the following tasks
with the DIS (Diagnosis and Information System):
-
Mix-up check of brake lines
-
Function check, hydraulic unit
Press clutch pedal down to floor and secure with pedal support.
Note:
The pedal support may only be released when the brake lines are
reconnected.
This prevents brake fluid from emerging from the expansion tank
and air from entering the system when the brake lines are opened.
Important!
Do not mix up brake lines.
If necessary, mark before removal.
Close off connection bores with plugs.
RA Removing and installing/replacing hydraulic unit for DSC (S85)
BMW AG - TIS
22.02.2013 21:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -