5 Series E60 M5 (S85) SAL
34 35 001
Replacing a brake pad sensor
Necessary preliminary tasks:
•
Remove wheel
Important!
The brake pad wear sensor must be replaced once it has
been removed (brake pad wear sensor loses its retention
capability in the brake pad).
If a brake pad sensor that has already been ground has to be
replaced even though the minimum brake pad thickness has
not yet been reached, you must observe the following: The
new sliding contact must be filed down with a file to the same
length as the ground sliding contact.
Open cover (1) on plug housing (3).
Unclip lead of brake pad sensor (2) from plug housing (3).
Disconnect associated plug connection of lead from brake pad
sensor (2).
Expose lead for brake pad sensor up to brake pad.
Press clip (1) together and detach brake pad sensor (2) in
direction of arrow from brake pad (3).
Installation:
Make sure clip (1) and brake pad sensor (2) are correctly seated
in brake pad (3).
RA Replacing a brake pad sensor
BMW AG - TIS
22.02.2013 21:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
