5 Series E60 M5 (S85) SAL
41 00 ...
Sectional repair of extruded aluminium
sections with repair elements
In the case of a partial replacement piece, an aluminum
extruded section is cut at a point described in the repair
instructions.
The following illustrations serve as schematic
representations.
Mark component in accordance with distance A and cut.
Adjust new part to fit with straightening attachment or universal
mount.
Drill holes in center of upper (1) and lower (2) cutting edges.
Hole diameter 10 mm.
Remove paint in upper and lower profile chambers on body and
new part. Measured from cutting edge, min. 50 mm deep into
each profile chamber.
The inside surfaces of the profile chambers must be smooth. They
must not feature any raised areas. If necessary, surface-grind rest
of rivet joints in chambers.
Grind outside of repair elements until bare.
Note:
The ribs on the repair elements must not be ground off.
Insert screws (2) into repair elements (1).
Coat repair elements (1) with adhesive.
RA Sectional repair of extruded aluminium sections with repair elements
BMW AG - TIS
22.02.2013 22:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
