5 Series E60 M5 (S85) SAL
Installation:
Use 2 EMC screws in areas (1).
Use 2 EMC screws in areas (3).
If an engine carrier partial replacement has been carried out, 2
EMC screws must be used in areas (2).
Note:
View from above
Mark severance cut in accordance with measurements a and b
and cut support carrier at top.
Measurement a =77 mm from recess
Measurement b =215 mm from center of bore
Note:
View from below
Mark severance cut in accordance with measurement a and cut
support carrier at bottom.
Measurement a =57 mm parallel to edge of spring support at
front
Installation:
Carry over bores from engine carrier to new part in areas (1).
Adapt new part with straightening attachment or universal mount
in area (2).
Drill through new part and engine carrier together.
Use 4 rivets (size 13) in areas (1).
Important!
If a partial replacement has already been carried out on the
engine carrier, rivets (size 15) must be used in areas (1).
RA Replacing left support carrier
BMW AG - TIS
22.02.2013 22:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
