5 Series E60 M5 (S85) SAL
Pull off liner* (1) only and kink all remaining liner protrusions
outwards.
Place rear-end trim section (2) on rear lid and magnetic
tapes (3).
Note:
Make sure that adhesives tapes at top do not come into contact
with rear lid.
Centre rear-end trim section (2).
Pull out magnetic tapes (3) and press on rear-end trim
section (2) at top.
Remove liner* (4) and press on rear-end trim section (2) at top.
Minimum application pressure is achieved by applying firm thumb
pressure in stages over the entire joining surface (hold time
approx. 1 second).
* Liner is the protective film on a rear-end trim section.
RA Replacing rear-end trim section
BMW AG - TIS
22.02.2013 23:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -